Geeetech

The printer works with Cura with no problems, when i add G21 (to set the metric in mm) in the start code. (Printer is located in Germany )

Hi, thank you for your answer. The Filament is not the Problem. It happens with every filament and allways, if i don`t swich off the Geeetech before starting the next print. It happens with two Versions of Cura. Cura 4.0.0 is fresh installed. Someone send me a file, which was sliced with slic3r pe. ...

Hi, i have an error with the Geeetech A30 (with auto leveling sensor / Printing from SD-Card / Firmware V1.36.57 / Hardware V3.2) . The first print works very well, but if i try to send a second print behind without switching off the device in between, the A30 does the Autoleveling, but instead of 3...

@Tomyuan

but bad for beginners who may not start with PLA and don`t know the gcode very well. (Like me two weeks ago *g*)
You won't be happy if the printer ignore the temperature information from Cura until you find out that the start code has fixed settings for the Temperature *g*.

Hi, thanks for the Settings :) i tried out Cura 4.0 with the Settings for Geeetech A30 from this download today. In the Start-Code are the Lines M109 S200;Heating nozzle M190 S60;Heating bed why? Doesn`t it means, it allways heats the Nozzle to 200°C and the Heatbead to 60°C, ignoring my Settings in...

As it is written in the manual you have to check first the AutoLeveling (on/off). I have done this with my Geeetech A30. In my case it was off and everything works. Meanwhile i have the AutoLeveling. There can also be a problem with ignoring the Z-Stop, if in the Cura-GCode the wrong Home-Position i...