Search found 3 matches

by Nic
Wed May 08, 2019 3:00 am
Forum: Geeetech A10 Series
Topic: 3D Touch crashes into bed
Replies: 1
Views: 2985

Re: 3D Touch crashes into bed

Thought I'd update ready for the next person to experience this. First I thought it must be a dodgy connection: it only happened when the nozzle was stretched away from the home position. Holding the wires as it moved to simulate the home position made no difference though, so I was stumped. Then fo...
by Nic
Thu May 02, 2019 4:37 am
Forum: Geeetech A10 Series
Topic: 3D Touch crashes into bed
Replies: 1
Views: 2985

3D Touch crashes into bed

Hi guys, I've seen similar problems to this, but not a definitive solution, so here goes. I've got an A10M and had the stock Marlin 1.1.8 in it, with Configuration.h modified to enable 3DTouch etc. It was all working fine, and bed levelling worked too (most of the time). Then it started crashing the...
by Nic
Sat Nov 24, 2018 10:45 pm
Forum: Mods And Hacks
Topic: 3d-touch pin falls during printing
Replies: 26
Views: 74363

Re: 3d-touch pin falls during printing

This worked a treat for me - pin was dropping and fouling prints before. I've taken one of these apart and I reckon it should be relatively easy to add a load of turns of copper wire to increase the pull of the solenoid - I'll post here if/when I get round to it.

Thanks for sharing.