Search found 1 match

by NightHawk
Sat Nov 24, 2018 1:11 am
Forum: Mods And Hacks
Topic: 3d-touch pin falls during printing
Replies: 26
Views: 31654

Re: 3d-touch pin falls during printing

I had this exact problem. So I took the pin out and ran it over a hard drive magnet and took some flush cutters and nipped off a very small piece (about .5mm or so) of the heatshrink on the pin. Now the pin sticks really good to the top but the solenoid can still pop it off.
Hope this helps.