Geeetech

I use both Slic3r and Cura 3.6. I use Cura the most but Slic can separate and cut parts, Rotate but not flip parts. Also Cura can Scale each axis separately.

I asked about layer shifting on the Facebook page . Repy was to lower the ACCel speed to 1000. I also lowered the Amax X to 2000, and the Amax Y 200 and lowered JERK to 10. Seems to help some parts I still run at 70-80 % speed

One of my table wheels was not touching the guide rail. so I adjusted it some so now all 4 wheels roll. I Still have my prints Constantly shifting off in the "Y+" direction . Not the "Y-" direction. And the slightest extra drag will knock the print off postion. I have ordered the stronger SKU 700-00...

Thanks I have been having problems with my prints shifting to the "Y+" side. and have noticed the bed travel catching or running over something on the rails. will check my roller wheels ).

It looks like your pushing too much filament out. when it cools the nozzele drags and overloads the stepper motor and skipps steps.

Some of my first ones were like that. I thought I was running PLA at 220* 60* bed 100% speed 100% flow. Then I realized I was using ABS ?? For the bed sticking problem I am using Blue Painters tape And Hairspray. just spray a light coat before each printing. ABS am running 250* Noz. 80* bed 90% spee...

My a-10 is shifting ocastionally all in the "Y+" direction. Running "ABS" at 250* ,bed at 80* speed 90-100%, Flowrate 80%. am I pushing too much filament out and dragging the nozzele. ?? But it only skip shifts in the "Y+" axis ??