Geeetech

I built it per docs and per videos online. I initially had some issues with the Z axis not working but following the instructions in the other post I got that sorted out. With everything working as expected.. I Leveled the bed and sliced the 20 mm calibration cube. I tried in easyprint 3d, repitier ...

in easyprint 3d the make sure you have the right com port and check the buad rate. Mine was set to 256000 and it should be 250000 at 256000 mine would not move either.

I followed these instructions and this worked well. I used synthetic gun lube on the threaded rods and all works well now. I have another problem but I will create another post for that.

if you losen the "yellow" nut would that not cause Z axis wobble?