Search found 7 matches
- Tue Oct 23, 2018 3:36 pm
- Forum: Geeetech I3 Aluminum
- Topic: the hot-end of my extruder mk8 is no longer able to extrude properly
- Replies: 1
- Views: 6867
the hot-end of my extruder mk8 is no longer able to extrude properly
I have a problem ... the hot-end of my extruder mk8 is no longer able to extrude properly, I continue problems from hitch, which according to what I have tried do not come from the nozzle blocked but from the throat ... that is, inside the screw where the thread inside the heater, it does not slip a...
- Wed Jan 24, 2018 4:58 am
- Forum: Software
- Topic: Prusa I3 X - Simplify3D Profile
- Replies: 8
- Views: 18326
Re: Prusa I3 X - Simplify3D Profile
i'm looking for simpify 3d profile... my printer is geeetech aluminium prusa i3
- Mon Jan 22, 2018 11:48 pm
- Forum: Software
- Topic: I looking for geeetech aluminum prisa I3 simplify3d profiles.
- Replies: 0
- Views: 3496
I looking for geeetech aluminum prisa I3 simplify3d profiles.
I'm looking for profiles to print with simplify3d for the geeetech aluminum printer. thanks
- Thu Dec 21, 2017 11:02 pm
- Forum: Discuss & Help
- Topic: frist layer speed too high
- Replies: 1
- Views: 4490
frist layer speed too high
question: we consider that to create a full and compact fill sli3cer orders the printer to make 3 layers, the speed of these 3 layers must be the same? if the answer is yes, then there is something wrong with the first layer because it is much faster than the other 2 layers to be able to lower it I ...
- Fri Nov 17, 2017 12:07 am
- Forum: Stepper Motor
- Topic: Possible solutions for motors do not move
- Replies: 39
- Views: 179461
Re: Possible solutions for motors do not move
thanks…. of course.. what you say is right…okey…well.. but the problem is…I try to adjust it. but I can not do it .. when I turn the potentiometer screw the electric current it transmits between the volt and 0,2 while if I turn to the right goes beyond the 2 volt. which is the full scale of the test...
- Thu Nov 16, 2017 11:30 pm
- Forum: Stepper Motor
- Topic: Possible solutions for motors do not move
- Replies: 39
- Views: 179461
Re: Possible solutions for motors do not move
thanks…. of course.. what you say is right…okey…well.. but the problem is…I try to adjust it. but I can not do it .. when I turn the potentiometer screw the electric current it transmits between the volt and 0,2 while if I turn to the right goes beyond the 2 volt. which is the full scale of the test...
- Thu Nov 16, 2017 6:40 am
- Forum: Stepper Motor
- Topic: Possible solutions for motors do not move
- Replies: 39
- Views: 179461
Re: Possible solutions for motors do not move
I'm having the problem on the y axis ... I tried setting the potentiometer but unfortunately I can not, or I have an electric current too low (0 or 0.2 volts) or I go over level. the tester is set to 2volt DC. what could be the problem, and obviously the solution?
thanks...
thanks...