Geeetech

There was no light designed in Rostock Delta 301, I had to use a small torch in order to observe my first few layer on the platform. I have now added 3 white LEDs surrounding the print extrude. The LED brackets are 3D printed. The LEDs are connected in serial and power supplied by 9V DC through a po...

Thanks bang, the problem has been solved. As I'm using Repetier, the default home sequence was 'G28 X0 ; home X axis', I have now updated with 'G28 ; home all axes' for all my configuration files.

My Rostock 301 does print well however when homeing after print, it always try to home X axis first while holding the Y and Z axis motor steady. The homing could never been complete as the X axis could only go half way to the home postion and stuck there. Manully homing could be completed without pr...

Got the problem solved. A pin at the connector of Y endstop stop switch was pushed out, as it usually should not. reseat the pin and the problem fixed.

Just got my rostock 301 setup. While homing, only X and Z moves up till hitting the limit switches, the Y motor seems locked at its axis and didn't move at all. I have tried 'Home' from both LCD control panel and REpetier software, the problem remained same. The Y motor physical connection is good. ...