Geeetech

We will have to buy another board . hahah

Yes.. I think the same... .. I swapped the pin of E0 and E1 in refer to this:
http://www.geeetech.com/forum/viewtopic ... 20&t=18020
Thats a really good information that technical suport of Geeetech gave me, but it doesnt work on my case..

Thank you William.. I did all things you say but its still happend the same thing, When I setting on the Repetier to extrude 100mm/min It extrude some 10mm/min and when I send it to print the motor just doesn't move. I change at frimware E0 with E1 and the change it works, but the problem persist!! ...

Hi! Im Vero from Argentina! The extruder of my Geeetech I3 ProB is not working correctly. I upload the frimware available in this forum but its still not working correctly. When I set to extrude 100mm/s It extrude only 10mm/s (but this shows that the motor works), but then when I send it to print th...

Hi! Im Vero from Argentina! The extruder of my Geeetech I3 ProB is not working correctly. When I set to extrude 100mm/s It extrude only 10mm/s (but this shows that the motor works), but then when I send it to print the motor of the extruder doesn't move even a little. I do all the steps on this post...

Hi! Im Vero from Argentina! The extruder of my Geeetech I3 ProB is not working correctly. When I set to extrude 100mm/s It extrude only 10mm/s (but this shows that the motor works), but then when I send it to print the motor of the extruder doesn't move even a little. I have another extruder so I c...

Hi! Im Vero from Argentina! The extruder of my Geeetech I3 ProB is not working correctly. When I set to extrude 100mm/s It extrude only 10mm/s (but this shows that the motor works), but then when I send it to print the motor of the extruder doesn't move even a little. I have another extruder so I ch...

Hi! Im Vero from Argentina! The extruder of my Geeetech I3 ProB is not working correctly. When I set to extrude 100mm/s It extrude only 10mm/s (but this shows that the motor works), but then when I send it to print the motor of the extruder doesn't move even a little. I have another extruder so I ch...