Hi Team
This is the firmware I have already tested with no results.
How would I check if there is a short circuit in the pins and how would I fix it if there was. If the board is physically faulty then I will require a replacement as the board was delivered to me DOA.
Regards
Ryan
Search found 2 matches
- Wed Oct 21, 2015 12:20 pm
- Forum: Control Board
- Topic: Switching GT2560 extruder connections
- Replies: 5
- Views: 10372
- Wed Oct 21, 2015 9:34 am
- Forum: Control Board
- Topic: Switching GT2560 extruder connections
- Replies: 5
- Views: 10372
Switching GT2560 extruder connections
Hi all I have recently purchased a "Geeetech Prusa i3 X" which runs off a GT2560 controller board. I have fully setup and tested the unit and everything appears to be working except the extruder is not extruding filament. - the hot end is running fine and I am running it a 220 degrees so temp is not...