Search found 2 matches

by ryan4all
Wed Oct 21, 2015 12:20 pm
Forum: Control Board
Topic: Switching GT2560 extruder connections
Replies: 5
Views: 5620

Re: Switching GT2560 extruder connections

Hi Team

This is the firmware I have already tested with no results.

How would I check if there is a short circuit in the pins and how would I fix it if there was. If the board is physically faulty then I will require a replacement as the board was delivered to me DOA.

Regards
Ryan
by ryan4all
Wed Oct 21, 2015 9:34 am
Forum: Control Board
Topic: Switching GT2560 extruder connections
Replies: 5
Views: 5620

Switching GT2560 extruder connections

Hi all I have recently purchased a "Geeetech Prusa i3 X" which runs off a GT2560 controller board. I have fully setup and tested the unit and everything appears to be working except the extruder is not extruding filament. - the hot end is running fine and I am running it a 220 degrees so temp is not...